FAAC Keypad & Intercom Repair Nationwide

FAAC Keypad & Intercom Repair: The Orlando Owner’s Guide

FAAC keypad and intercom repair in Orlando typically runs $220 to $480 installed, depending on whether we’re replacing the keypad face, the intercom module, or the full entry station. We stock FAAC-compatible keypads, intercom boards, and weather seals on our trucks, and most jobs are done in a single visit. The way owners usually find us: the keypad works sometimes, the intercom audio cuts out when a visitor buzzes, or the gate simply stops responding to a code that worked last week.

Call (321) 465-7089

You’ll know the price before I touch anything. That’s how Cole Rafferty runs every job at Warden Gate Repair Orlando, and it applies whether we’re swapping a single keypad or rewiring an entire entry station.

Which FAAC Models This Applies To

We service keypads and intercoms across the FAAC residential and light-commercial lines you’ll find throughout Orlando neighborhoods like Baldwin Park, College Park, and Dr. Phillips. The most common units we see are the FAAC XKPR keypad, the KP 20 and KP 30 series, the DIGIKEY, and entry stations paired with 412, 455 D, and 770 operator boards. These keypads and intercoms are not universal. A keypad wired for a 455 D won’t necessarily communicate cleanly with a 770 without a module change.

Identifying your part is usually straightforward: open the keypad housing and look for a white or silver label with the FAAC part number stamped on it. If the label has worn off, which happens faster in Florida humidity than you’d expect, photograph the keypad face and the wire terminals and send it to us before the visit. That gets the right part on the truck the first time.

On the OEM-versus-aftermarket question: for FAAC keypads specifically, we default to OEM replacements. The reason is simple. FAAC keypads use a proprietary snap-in wiring harness, and the aftermarket equivalents we’ve tested in Orlando’s damp, hot summers fail at the membrane seal twice as fast. For intercom modules, a quality aftermarket board can be a good value if the OEM part is backordered. We’ll tell you which route makes sense for your specific model and quote both ways. We’re an independent service provider, not affiliated with FAAC, which means we can recommend what actually works rather than what a brand rep wants to sell.

We also stock keypads and intercoms from LiftMaster, Mighty Mule, and Ghost Controls for owners running mixed-brand setups.

Signs Your FAAC Keypad & Intercom Repair Is Failing

• Codes work intermittently, usually after rain. Moisture has gotten past the membrane or into the wiring harness. In Orlando’s afternoon thunderstorms, a hairline crack in the keypad face lets water pool against the contact pads, and the keypad reads buttons you never pressed.
• Visitors report no audio or choppy audio at the intercom. The intercom speaker cone degrades in high humidity, or the audio board has corrosion at the terminal block. We see this more often on gates facing south, where the entry station catches full sun and cooks in the afternoon heat.
• The keypad beeps but the gate doesn’t move. The keypad is sending signal, which means the failure is downstream in the operator board or the wired connection. This is a diagnostic call, not a keypad replacement call, and we don’t charge for guesses.
• One row of keys stops responding. That’s a failed membrane trace, not a wiring problem. FAAC keypads use a flexible printed circuit inside the face, and once one trace oxidizes, the whole row goes dark.
• The keypad backlight flickers or dies. The backlight module has a finite lifespan, usually 4 to 7 years in this climate. If the keypad still works but the light is dead, you can keep running it, but the next thing to go is usually the membrane.

Replacement Cost & What’s Included

A FAAC keypad replacement in Orlando generally falls between $220 and $340 installed. A full keypad-plus-intercom entry station swap runs higher, usually $380 to $480, because the intercom audio board and speaker are separate components. A bare intercom module repair, if the cabinet and speaker are still solid, lands around $180 to $260.

Every quote includes the part, the labor to wire it correctly, a full test cycle with the gate operator, and the written price before any work begins. No line items appear at the end that weren’t on the estimate. The installed replacement is covered by our 365-Day Done Right Promise: if the repair isn’t right, we come back and make it right at no charge. The written price is what you pay, and the tech’s name and photo arrive on your phone before the truck rolls.

DIY or Call Us?

What you can safely check: whether the keypad has visible cracks or water inside the face, whether the wire terminals at the operator board are tight, and whether the operator itself powers on. Those checks cost nothing and give us useful information when you call.

What we’d caution against: opening a FAAC keypad and probing the ribbon cable while the gate is powered. The operator board carries live 24V on the keypad terminals, and a short in the wrong spot can take out the board that runs your gate. That’s when a $300 keypad job becomes an $900 operator board replacement. If you’re handy and the keypad clearly has a dead membrane, you can swap the faceplate with the correct OEM part. But if the symptom is intermittent or the intercom audio is failing, that’s a diagnostic job. Call us at (321) 465-7089 and we’ll walk through what you’re seeing before anyone schedules a visit.

FAQs